Test Method for Determination of Hydraulic Conductivity of Porous Material Using a Rigid-wall Compaction-Mold Permeameter. Start. Standard ASTM standard · ASTM D Status: Withdrawn · Replaced by: ASTM D Soil and Rock (I): D – D (ASTM VOL ). ASTM D Standard Test Method for Measurement of Hydraulic Conductivity of Porous Material Using a Rigid-Wall, Compaction-Mold.
|Published (Last):||13 April 2015|
|PDF File Size:||5.47 Mb|
|ePub File Size:||13.27 Mb|
|Price:||Free* [*Free Regsitration Required]|
This test method applies to porous materials containing little or no air. It was not possible to unsubscribe – please try again later or contact the Danish Standard Please make sure you are logged in.
There is a problem adding monitoring – please try again later There is a problem adding the subscription – please try again later.
Link to Active This link will always route to the current Active version of the standard. By tradition in U. Therefore, the results should be applied to field situations with caution and by qualified personnel.
Are you sure you want to unsubscribe? Experience has sometimes shown that flow patterns in small, laboratory-prepared test specimens do not necessarily follow the same patterns on large field scales and that hydraulic conductivities measured on small test specimens are not necessarily the same as larger-scale values. xstm
Activation of monitoring failed – please try again later or contact us. Permeation with other liquids, such as chemical wastes, can be accomplished using procedures asstm to those described in this test method.
ASTM D5856 – 15
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applic.
The hydraulic conductivity of compacted materials that have hydraulic conductivities greater than 1? Reliable results depend on many factors; Practice D provides a means of evaluating some of those factors. Continue shopping Proceed to checkout. Kontakt venligst F5856 Standard. Test Method D is recommended for any material that aatm to shrink when exposed to the permeant liquid.
However, when the astk gradient acting on a test specimen is changed, the state of stress will also change, and, if the specimen or pore fluid is compressible, the volume of the test specimen or pore fluid will change.
Historical Version s – view previous versions of standard. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Please choose number of devices you want to open the document aetm. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Do not show this again. Users of this standard are cautioned that compliance with Practice D does not in itself ensure reliable results. However, this test method does not ensure complete saturation of the test specimen with water.
By tradition in U. Username or password invalid. However, this test method is only intended to be used when water is the permeant liquid. It is not possible to buy in the shop – please contact us. The test method is designed to minimize the amount of air in the test specimen. The printed version is available at half price when you buy the electronic version.
ASTM D Standard
In cases where it is essential to zstm the test specimen fully with water, the compacted specimen may be tested using Test Method D You must be logged in to sign up for monitoring You must be logged in to sign up for subscription. Du abonnerer allerede dette emne.
Activation of your subscription failed – please try again later or contact us. Are you sure you want to unsubscribe monitoring? The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. The problem tends to be of minimal significance for materials that swell when exposed to water for example, compacted, clayey soils but can be a very serious problem for materials that might tend to shrink and pull away from the walls of the permeameter.